User Tools

Site Tools


m0dul

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
m0dul [2011/06/20 23:03]
kiu [Dual M0duls]
m0dul [2011/12/30 00:10] (current)
emdete
Line 1: Line 1:
 +====== Intro ======
 +
 The r0ket can easily be extended by pluggable m0duls. The r0ket can easily be extended by pluggable m0duls.
  
-See [[m0duls|m0duls]] for existing m0duls.+See [[m0duls]] for existing m0duls.
  
 ====== Hardware ====== ====== Hardware ======
Line 35: Line 37:
  
 ==== Single M0duls ==== ==== Single M0duls ====
-A single m0dul only uses one m0dul connector. These modules ​go to the side of the badge. By rotating the m0dul you can chose to either mount it on the left or the right side of the r0ket.+A single m0dul only uses one m0dul connector. These m0duls ​go to the side of the badge. By rotating the m0dul you can chose to either mount it on the left or the right side of the r0ket.
  
 {{:​m0dul-single.brd.png?​direct&​200|}} {{:​m0dul-single.brd.png?​direct&​200|}}
Line 53: Line 55:
 | BUSINT | Active LOW open-drain interrupt ​ | | BUSINT | Active LOW open-drain interrupt ​ |
  
-====== ​Software ​======+====== ​Further reading ​======
  
-[[build|Build]] explains how to set up your build-environment and compile and deploy code for r0ket.+  * [[build]] explains how to set up your build-environment and compile and deploy code for [[r0ket]] 
 +  * You can either write your own firmware, or, if your code is smaller than 1 kB, a [[l0dable]] which can be dynamically loaded into the default firmware.
  
-You can either write your own firmware, or, if your code is smaller than 1 kB, a [[loadable]] which can be dynamically loaded into the default camp firmware. 
m0dul.1308603817.txt.gz · Last modified: 2011/06/20 23:03 by kiu